Maintenance
Pos: 64.22 /Überschriften/Überschriften 2/A-E/Einstellung der Schneidmesser der Netzwickeleinrichtung @ 236\mod_1394520153957_78.docx @ 1873221 @ 2 @ 1
13.4
Setting Cutting Blade Net Tying Device
Pos: 64.23 /WHB/Warnhinweise - Allgemeingültig/VORSICHT - Verletzungsgefahr durch scharfe Messer - Nicht die Messer berühren, Schutzhandsch... @ 55\mod_1292838132223_78.docx @ 523692 @ @ 1
CAUTION! – Risk of injury from sharp blades
•
Do not touch the blades on the blade bar.
•
Wear protective gloves.
Pos: 64.24 /BA/Wartung/Rundballenpresse/Einstellung Schneidmesser Netzwickeleinrichtung @ 34\mod_1256118782238_78.docx @ 326151 @ @ 1
13.4.1
Adjusting the cutting blades of the net wrap system
1
Fig. 241
If the blade bar stop (1) is resting against the stop (2), there should be a gap of a = approx. 2
mm from the spring rail (3) to the bearing tube (4) or b = 8 mm from the bearing (6) to the
bearing tube (4).
Adjusting procedure:
•
Loosen screw (5).
•
Move until dimension a = 2 mm.
•
Tighten the screw (5).
Pos: 64.25 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0.docx @ 4165 @ @ 1
280
a=2mm
6
2
3
5
b=8mm
4
RP-B-003