Settings
Pos: 62.21 /Überschriften/Überschriften 3/A-E/A/Andrückrolle einstellen @ 33\mod_1253783433270_78.docx @ 317295 @ 3 @ 1
12.1.4
Adjusting the idler roller
Pos: 62.22 /BA/Bedienung /Rundballenpresse/Bild Andruckrolle @ 33\mod_1253784658363_78.docx @ 317341 @ @ 1
3
Fig. 220
Pos: 62.23 /BA/Bedienung /Rundballenpresse/Andrückrolle einstellen @ 33\mod_1253783906629_78.docx @ 317316 @ @ 1
If the twine is not being drawn in correctly at the start, the pressure of the idler roller can be
increased with the spring (2):
Right-hand side
1. Detach spring (2).
2. Remove the screw (3) and mount it in one of the top holes.
3. Reattach the spring (2).
Left-hand side
Pressure can be increased by hooking the spring into the holes.
Pos: 62.24 /Überschriften/Überschriften 3/P-T/Sensor einstellen @ 33\mod_1253792942785_78.docx @ 317601 @ 3 @ 1
12.1.5
Adjusting the sensor
Pos: 62.25 /BA/Einstellungen/Rundballenpresse/Bild Einstellung Sensor @ 33\mod_1253793123473_78.docx @ 317697 @ @ 1
4
Fig. 221
Pos: 62.26 /BA/Einstellungen/Rundballenpresse/Einstellung Sensor @ 33\mod_1253793023160_78.docx @ 317622 @ @ 1
To allow for the twine not always starting or being cut off in the same place, the sensor (1) can
be moved left or right.
1. Loosen the screw (4).
2. Move the sensor support (1).
3. Retighten the screw.
Pos: 62.27 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0.docx @ 4165 @ @ 1
264
2
1
VP-3-014
RBV00021