Krone Fortima F 1250 Original Operating Instructions page 228

Operation
Pos: 60.41.21 /BA/Einstellungen/Schneidwerk/Einstellen der Einzelmessersicherung ohne Schraube VP @ 39\mod_1268816727179_78.docx @ 362127 @ @ 1
Adjusting the locking device for blades
2
1
8
Fig. 181
1. Lowering the cutting system
2. Switch off the control unit and remove the ignition key
3. Secure the machine against the possibility of rolling back
4. Unscrew the counter nut (2).
5. Turn adjusting screw (1) far enough so that the dimension you require is reached
6. Tighten counter nut (2)
If an adjustment by adjusting screw is not possible:
1. Detach the spring at the pivoted lever (9)
2. Remove the screw (8)
3. Swing the cylinder (3) laterally aside
4. Remove pivoted lever (9)
5. Pull off selector disc (6) of the toothed blade control shaft (7)
6. Slide on selector disc (6) again offset one tooth
Note
Install the grooved ball bearing in reverse order to the removal procedure.
Pos: 60.41.22 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0.docx @ 4165 @ @ 1
228
3
5
6
9
7
VP-1-063