Maintenance
Pos: 64.42 /Überschriften/Überschriften 2/A-E/Deichsel @ 236\mod_1394526379904_78.docx @ 1873562 @ 2 @ 1
13.10
Drawbar
Pos: 64.43 /BA/Sicherheit/8. Voraussetzungen/Handlungsanweisung für alle Maschinen/Handlungsanweisung: Maschine stillsetzen und sichern @ 274\mod_1404365253849_78.docx @ 2065151 @ @ 1
•
Shut down and safeguard the machine, see chapter Safety -> Safety routines, "Shutting
down and safeguarding the machine".
Pos: 64.44 /BA/Wartung/Rundballenpresse/Deichsel @ 236\mod_1394527540776_78.docx @ 1873771 @ @ 1
Fig. 252
•
Retighten the screws after 10 operating hours.
•
Check the screws every 50 operating hours.
Pos: 64.45 /Überschriften/Überschriften 3/U-Z/Zugösen an der Deichsel @ 236\mod_1394528187810_78.docx @ 1873833 @ 3 @ 1
13.10.1
Hitches on the Drawbar
Pos: 64.46 /BA/Wartung/Zugösen/Zugösen a=43 an der Deichsel @ 236\mod_1394528163742_78.docx @ 1873804 @ @ 1
Fig. 253
Caution!
If the wear limit of the socket in the towing ring has been reached, it must be replaced. Work on
the drawbar must only be performed by trained professionals.
The wear limit of the socket in the towing ring (1) is a = 43 mm. If this value is exceeded, the
socket must be replaced. To minimise wear, clean the socket and towing ring daily and lubricate
them with grease.
Note
The towing ring should be coupled always horizontally in the towing hitch. Observe the correct
combination of towing ring and towing hitch (observe the specifications on the type plate!)
Pos: 64.47 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0.docx @ 4165 @ @ 1
292
a
KDW02330
RP-2-002