Krone Fortima F 1250 Original Operating Instructions page 224

Operation
3
Fig. 177
3. Turn blade control shaft with multipurpose key (1) counter-clockwise into the desired
position (2).
4. Turn locking lever (3) counter-clockwise until it engages.
Note
Do not turn locking lever in the other direction (clockwise). In doing so, the possibility exists that
the cutters are not located in working position.
5. Remove the multipurpose key (1), put it correctly down into transport support and secure it
with spring cotter pin.
Note
After adjusting make certain that the cutters are located in working position.
Pos: 60.41.10 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0.docx @ 4165 @ @ 1
224
1
2
CP101251