Krone Fortima F 1250 Original Operating Instructions page 175

Pos: 52.99 /BA/Info-Center/Sensoren/Diagnose analoge Sensoren @ 19\mod_1238132263369_78.docx @ 214965 @ @ 1
Diagnostics – analogue sensors
Pos: 52.100 /BA/Info-Center/Sensoren/Einstellwerte analoge Sensoren Hand @ 19\mod_1238132357119_78.docx @ 214994 @ @ 1
Setting values:
The bar must be inside the marked area of the bar display.
Pos: 52.101 /BA/Info-Center/Sensoren/Mögliche analoge Sensoren (je nach Ausstattung der Maschine) @ 19\mod_1238132689353_78.docx @ 215041 @ @ 1
Possible analogue sensors (depending on how the machine is equipped)
Pos: 52.102 /BA/Info-Center/CCI-ISOBUS-Terminal/CCI-Rundballenpressen/Hauptmenüs/Hauptmenü 4 Service/Mögliche analoge Sensoren Fortima V und F @ 251\mod_1397022589683_78.docx @ 1938965 @ @ 1
No. Sensor symbol
B9
B10
Pos: 52.103 /BA/Info-Center/Sensoren/Statusanzeigen/Statusanzeige analoge Sensoren (7,8) @ 19\mod_1238133054056_78.docx @ 215095 @ @ 1
State:
Broken cable or short circuit
Defect in the sensor or job computer
Pos: 52.104 /BA/Info-Center/Rundballenpresse/Hauptmenü 4 Service/Zur Lage der Sensoren siehe Kapitel Wartung „Lage der Sensoren". @ 250\mod_1396968441354_78.docx @ 1938360 @ @ 1
For information on the position of the sensors, please refer to chapter Maintenance "Position of
Sensors".
Pos: 52.105 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0.docx @ 4165 @ @ 1
Description
Bale diameter left (Fortima V)
Bale firmness left (Fortima F)
Bale diameter right (Fortima V)
Bale firmness right (Fortima F)
KRONE ISOBUS Terminal
175