Adjusting The Drawbar Height - Krone Fortima F 1250 Original Operating Instructions

Commissioning
Pos: 46.23 /Überschriften/Überschriften 2/F-J/Höhenanpassung der Deichsel @ 17\mod_1236255816988_78.docx @ 204061 @ 2 @ 1
5.3

Adjusting the drawbar height

Pos: 46.24 /BA/Erstinbetriebnahme/Rundballenpresse/Anpassen des Reifenluftdrucks Rundballenpressen @ 114\mod_1338881601674_78.docx @ 1006469 @ @ 1
Note
Before aligning the machine and adapting the height of the drawbar, the tyre pressure must be
checked and adapted to the value for the existing tyre type which is recommended in the tyre
air pressure table (refer to chapter entitled "Maintenance"), if necessary.
Pos: 46.25 /BA/Erstinbetriebnahme/Rundballenpresse/Deichselhöhe anpassen_Fortima @ 244\mod_1395761594338_78.docx @ 1908344 @ @ 1
Fig. 35
Note
To guarantee optimum working, the machine has to be hitched in a way that the dimension X is
approx. 530 mm. The dimension X is measured from the ground up to the middle of the lower
head of the screw and has to be adjusted to the respective harvesting conditions as well as the
tyre size.
68
X
RBV0425A_1