Operation
Pos: 60.41.5 /BA/Einstellungen/Schneidwerk/Schnittlänge einstellen/Schnittlänge VarioPack @ 306\mod_1416320194627_78.docx @ 2382104 @ 3 @ 1
11.13.2
Cutting length
The cutting length is determined by the number of inserted blades.
The number of inserted blades can be read off on the dial (1). In the diagram below 15 blades
have been put in.
Fig. 174
Pos: 60.41.6 /BA/Einstellungen/Schneidwerk/Schnittlänge einstellen/Schnittlänge Tabelle durch Messerbestückung VarioPack @ 39\mod_1268808933991_78.docx @ 361836 @ @ 1
Table cutting length depending on blade equipping
Cutting length
128 mm
64 mm
64 mm
* The two outer cutters are turned off.
Pos: 60.41.7 /BA/Einstellungen/Schneidwerk/Mehrzweckschlüssel VarioPack @ 39\mod_1268809193085_78.docx @ 361861 @ @ 1
Fig. 175
Setting is carried out via multipurpose keys (3) or (4).
These are located in a support on the right side of the machine.
1. Remove spring cotter pin (1)
2. Pull multipurpose key (3) or (4)
Pos: 60.41.8 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0.docx @ 4165 @ @ 1
222
1
VP-1-058_1
Number of blades
0
7
15*
17
CPB00050
off from the retaining bolt (2).
Setting
"0"
„7"
„15"
„17"