Menu 4-2 "Manual Sensor Test - Krone Fortima F 1250 Original Operating Instructions

KRONE operation terminal Beta
Pos: 50.38.5 /Überschriften/Überschriften 3/K-O/Menü 4-2 Sensortest Hand @ 34\mod_1255414500878_78.docx @ 322861 @ 3 @ 1
7.10.1

Menu 4-2 "Manual Sensor Test"

Pos: 50.38.6 /BA/Info-Center/Rundballenpresse/Hauptmenü 4 Service/Bild Menü 4-2 Sensortest Hand @ 187\mod_1380114678068_78.docx @ 1610095 @ @ 1
Fig. 96
Pos: 50.38.7 /BA/Info-Center/Rundballenpresse/Hauptmenü 4 Service/Menü 4-2 Sensortest Hand Fortima @ 251\mod_1397036444964_78.docx @ 1940784 @ @ 1
In the manual sensor test, the sensors installed on the machine are checked for faults. In
addition, the sensors can be adjusted correctly. There is no guarantee the machine is working
correctly until after the sensors have been adjusted.
Caution!
Make sure that the PTO shaft does not turn during the sensor test.
Calling the menu
Main menu 4 "Service" is called.
• Select menu 4-2
• Press
The display shows menu 4-2 "Manual Sensor Test".
Selecting the sensor
• Select the sensor with
The selected sensor is displayed inversely and is tested.
Pos: 50.38.8 /BA/Info-Center/Sensoren/Einstellwerte Sensortest Hand @ 19\mod_1238069756191_78.docx @ 213845 @ @ 1
Setting values:
The minimum and maximum setting values with the sensor alive (metal in front of the sensor)
are shown in the upper part of the bar display. The current setting value (actual value) is
displayed under the bar display.
The distance from the sensor to the metal must be adjusted so that in the alive state the bar is
in the upper mark. Next check whether the bar is in non-alive state in the lower marked area.
Pos: 50.38.9 /BA/Info-Center/Rundballenpresse/Hauptmenü 4 Service/Zur Einstellung der Sensoren siehe Kapitel Wartung „Einstellung der Sensoren". @ 250\mod_1396968606268_78.docx @ 1938388 @ @ 1
To adjust the sensors, refer to chapter Maintenance "Setting the Sensors".
Pos: 50.38.10 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0.docx @ 4165 @ @ 1
128
with or
key.
or
keys, the symbol is shown in reverse colours.
keys.
RPK50508