Pos: 60.6.1 /BA/Bedienung /Rundballenpresse/Einstellungen vor Arbeitsbeginn/Einstellungen vor Arbeitsbeginn Fortima @ 230\mod_1393311445585_78.docx @ 1842011 @ 2 @ 1
11.1
Settings Before Starting Work
Before starting work, perform or check the following settings for all machine types:
•
Working height of the pick-up
•
Position of the baffle plate
•
Switching on or switching off cutting system (special equipment)
•
Cutting length of the cutting system (special equipment)
•
Using a bale ejector (special equipment)
•
Selecting twine tying or net tying (depending on the design)
•
Inserting twine or net (depending on the design)
•
Function of chain lubrication, topping up oil, if necessary
•
Resetting bale counter
Pos: 60.6.2 /BA/Bedienung /Rundballenpresse/Einstellungen vor Arbeitsbeginn/Bei Fortima V 1500 (MC)/V 1800 (MC) zusätzlich folgende Einstellungen vornehmen: @ 230\mod_1393311529075_78.docx @ 1842109 @ @ 1
For Fortima V 1500 (MC)/V 1800 (MC), the following settings must be made additionally:
Pos: 60.6.3 /BA/Bedienung /Rundballenpresse/Einstellungen vor Arbeitsbeginn/Bei Fortima V 1500 (MC)/V 1800 (MC) zusätzlich folgende Einstellungen vornehmen_Text @ 230\mod_1393311922832_78.docx @ 1842178 @ @ 1
•
Tighten the floor conveyor of the bale chamber
Fig. 162
•
Swivel stop cock (1) of control valve (2) from position "a" to position "b". Lifting tailgate
•
Use of additional tappet strips (depending on the crop)
•
Preselect bale size
Pos: 60.6.4 /BA/Bedienung /Rundballenpresse/Einstellungen vor Arbeitsbeginn/Bei Fortima F 1250 (MC)/F 1600 (MC) zusätzlich folgende Einstellungen vornehmen: @ 230\mod_1393311522596_78.docx @ 1842070 @ @ 1
For Fortima V 1250 (MC)/V 1600 (MC), the following settings must be made additionally:
Pos: 60.6.5 /BA/Bedienung /Rundballenpresse/Einstellungen vor Arbeitsbeginn/Bei Fortima F 1250 (MC)/F 1600 (MC) zusätzlich folgende Einstellungen vornehmen_Text @ 230\mod_1393311924606_78.docx @ 1842207 @ @ 1
•
Preselect bale firmness
Pos: 60.6.6 /BA/Bedienung /Rundballenpresse/Einstellungen vor Arbeitsbeginn/Arbeitsschritte sind in den Kapiteln "Einstellungen" und "Bedienung" beschrieben. @ 230\mod_1393313121984_78.docx @ 1842236 @ @ 1
The necessary working steps are described in the chapters entitled "Settings" and
"Operation".
The baling pressure must be reduced.
Pos: 60.7 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0.docx @ 4165 @ @ 1
1
2
b
a
VP-1-036
Operation
209