Pick-Up; Default Setting (Working Height Setting) - Krone Fortima F 1250 Original Operating Instructions

Operation
Pos: 60.23 /Überschriften/Überschriften 2/P-T/Pick up @ 1\mod_1201791975201_0.docx @ 54586 @ 2 @ 1
11.8

Pick-up

Pos: 60.24 /Überschriften/Überschriften 2/F-J/Grundeinstellung (einstellen der Arbeitshöhe) @ 19\mod_1238576636385_78.docx @ 221585 @ 2 @ 1
11.9

Default Setting (Working Height Setting)

Pos: 60.25 /BA/Einstellungen/Pick-up / Rollenniederhalter/Hinweis Fahren im Vorgewende @ 20\mod_1238578490213_78.docx @ 221874 @ @ 1
Note
Lift the Pick-up for driving in the headland or when driving backward!
Pos: 60.26 /BA/Sicherheit/8. Voraussetzungen/Handlungsanweisung für alle Maschinen/Handlungsanweisung: Maschine stillsetzen und sichern @ 274\mod_1404365253849_78.docx @ 2065151 @ @ 1
• Shut down and safeguard the machine, see chapter Safety -> Safety routines, "Shutting
down and safeguarding the machine".
Pos: 60.27 /BA/Einstellungen/Pick-up / Rollenniederhalter/Pick-up Grundeinstellung Bild VarioPack @ 32\mod_1253622927843_78.docx @ 315722 @ @ 1
Fig. 168
Pos: 60.28 /BA/Einstellungen/Pick-up / Rollenniederhalter/Pick-up Grundeinstellung VP @ 32\mod_1253623550687_78.docx @ 315801 @ @ 1
Note
When adjusting the pick-up, the drawbar height of the machine must be adjusted to the tractor
(see chapter "Initial start-up").
The distance from the tines to the ground must be about 20 – 30 mm.
Adjust the pick-up working height according to the prevailing ground conditions.
Default setting (the setting must always be the same on both sides):
• Raise the pick-up (3) hydraulically
• Remove the linch pin (2)
• Set the perforated bar (1) in the required position
• Secure in place using the linch pin (2)
Pos: 60.29 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0.docx @ 4165 @ @ 1
216
2
1
3
RBV04181