Pos: 42.31 /Überschriften/Überschriften 3/A-E/A/Anschlagpunkte @ 168\mod_1368430700205_78.docx @ 1453905 @ 3 @ 1
4.8.6
Stop Points
Pos: 42.32 /BA/Sicherheit/7. Gefahrenhinweise alt/Warnung - Anheben @ 168\mod_1368433456450_78.docx @ 1454049 @ @ 1
WARNING!
Danger from falling loads!
•
Never step or stay under suspended loads!
•
Maintain an adequate safety distance from suspended loads.
•
Before transportation, compare load capacity of slings and cranes and choose
transportation equipment with a sufficient degree of safety and lifting capacity.
•
Prevent strong impacts and make sure that the machine does not become wedged!
Pos: 42.33 /BA/Wartung/Rundballenpresse/Anheben der Maschine @ 114\mod_1338467456755_78.docx @ 1003130 @ 33 @ 1
4.8.7
Lifting Eyes
The baler is equipped with three suspension points:
•
A suspension point is located in the front area of the drawbar.
•
Two suspension points can be found rear on the yoke (right and left upper machine side).
4.8.8
Lifting
•
Use a lifting traverse with a minimum load-bearing capacity (depending on the permitted
gross weight of the machine) (refer to Chapter entitled Introduction "Identification")
•
Close the tailgate
•
Swivel the parking support (parking jack) into transport position
•
Lift the pick-up
•
Make certain all safety devices are locked
•
Attach the chains of the lifting traverse to the four suspension points of the machine
•
Make sure that the hooks of the chains are attached correctly on the suspension points
Pos: 42.34 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0.docx @ 4165 @ @ 1
Safety
49