Pos: 24.25 /BA/Sicherheit/1. Grundlegende Sicherheitshinweise/Betriebssicherheit - Technische Grenzwerte @ 176\mod_1372857251111_78.docx @ 1506647 @ @ 1

Technical limit values

If the technical limit values of the machine are not observed, the machine may be damaged. As

a result, accidents may occur and people may be seriously injured or killed. Observance of the

following technical limit values is particularly important for safety:

–

Permitted gross weight

–

Maximum axle loads

–

Maximum payloads

–

Maximum trailer load

–

Maximum bearing load

–

Maximum transport height

–

Maximum speed

•

Observe limit values, see chapter Description of machine, "Technical data".

Pos: 24.26 /Überschriften/Überschriften 3/F-J/Gefahrenbereiche @ 187\mod_1380012427290_78.docx @ 1606906 @ 3 @ 1

4.4.9

Danger zones

Pos: 24.27 /BA/Sicherheit/1. Grundlegende Sicherheitshinweise/Gefahrenbereiche rund um Anhängegerät, Anbaugerät o. Anhänger T1 @ 176\mod_1372858104099_78.docx @ 1506686 @ @ 1

Danger zones on the tractor and the machine

The area around the tractor and the machine is a danger zone.

There are the following hazards in this danger zone:

–

The tractor and the machine may start moving or rolling away and run over people.

–

If the power lifter is unintentionally actuated, the machine may make hazardous

movements.

–

Defective or insecurely attached electrical cables may cause fatal electric shocks.

–

Defective or insecurely attached hydraulic or pneumatic lines may become detached and

flail around. Hydraulic oil may escape under high pressure and cause serious injuries to the

skin or face.

–

Clothing may become caught and wrapped around an exposed PTO shaft or a damaged or

incorrectly installed universal shaft.

–

When the drive is switched on, machine parts may rotate or swivel.

–

Hydraulically raised machine parts may descend unnoticed and slowly.

Pos: 24.28 /BA/Sicherheit/1. Grundlegende Sicherheitshinweise/Gefahrenbereiche rund um Anhängegerät, Anbaugerät o. Anhänger T2 @ 273\mod_1404140364724_78.docx @ 2059727 @ @ 1

If the danger zone is not observed, people may be seriously injured or killed.

•

Keep people away from the danger zone of the tractor and the machine.

•

Do not switch on the drives and engine until there is nobody in the danger zone.

The safety clearance is:

–

3 metres on either side of the machine.

–

5 metres behind the machine.

•

Before working in front of and behind the tractor and in the danger zone of the machine: •