Pos: 62.16 /Überschriften/Überschriften 3/F-J/Garnbremse lösen @ 33\mod_1253798186457_78.docx @ 318052 @ 3 @ 1
12.1.3
Loosening the twine brake
Pos: 62.17 /BA/Einstellungen/Rundballenpresse/Bild Garnbremse lösen @ 33\mod_1253798290676_78.docx @ 318077 @ @ 1
Fig. 218
Pos: 62.18 /BA/Bedienung /Rundballenpresse/Netz-Garnbindung/Garnbremse lösen @ 33\mod_1253782791316_78.docx @ 317236 @ @ 1
1. Move the tension arm (2) from below into central position.
In this position
•
the tension spring (3) must not be tensioned,
•
tension on the wire rope (4) must be slightly released.
Pos: 62.19 /BA/Einstellungen/Rundballenpresse/Garnbremse Verstellhebel @ 54\mod_1291810376468_78.docx @ 516045 @ @ 1
Fig. 219
The brake is released by the adjusting lever (1) when starting.
Setting the twine brake (depends on yarn count):
1. Turn the screw (2) clockwise (thicker yarn count)
2. Turn the screw (2) anticlockwise (thinner yarn count)
Note
When the adjusting lever (1) is pressed, both brake plates (3) have to be raised evenly. If this is
not the case, on can adjust with screws (2).
Pos: 62.20 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0.docx @ 4165 @ @ 1
2
CP400005_1
CP400006
1
3
Settings
263