Differing Functions To Krone Isobus Terminal Cci - Krone Fortima F 1250 Original Operating Instructions

ISOBUS operation
Pos: 54.8 /BA/Info-Center/Iso-Bedienung/BigPack/Abweichende Funktionen zum KRONE ISOBUS-Termina CCI @ 47\mod_1285223499328_78.docx @ 455993 @ 2 @ 1
9.2

Differing functions to KRONE ISOBUS terminal CCI

Via the accessory unit, the ISOBUS control unit will provide information and control functions to
the display of the ISOBUS terminal. Operation with an ISOBUS terminal is analogue to the
KRONE ISOBUS terminal CCI. Prior to start-up, refer to the operating instructions for the
method of operation of the KRONE ISOBUS terminal CCI.
A fundamental difference to the KRONE ISOBUS terminal CCI is the arrangement of the
softkeys, which are determined by the selected ISOBUS terminal.
Only the functions that differ from the KRONE ISOBUS terminal CCI are described in the
following.
Pos: 54.9 /BA/Info-Center/Iso-Bedienung/Rundballenpressen/Abweichende Funktionen CCI_Terminal_Ballengröße Fortima @ 80\mod_1315396808185_78.docx @ 704134 @ @ 1
Note
The values for the "bale size", which are set via the scroll wheel for the KRONE ISOBUS -
terminal CCI, are carried out at the ISO terminal via the selection key specified by the ISO
terminal (refer to the operating instructions of the ISO terminal manufacturer).
Pos: 54.10 /BA/Info-Center/Iso-Bedienung/Abweichende Funktionen CCI_Term Menüpunkt 1-4 „Kontrast" @ 48\mod_1286276672656_78.docx @ 460458 @ @ 1
Note
Menu item 1-4 "Contrast" of the KRONE control cannot be called up on the ISOBUS terminal. A
setting is performed directly via the ISOBUS terminal (if applicable) (refer to operating
instructions of the ISOBUS terminal manufacturer).
If necessary, acoustic signals must be enabled from the terminal (refer to operating instructions
of the ISOBUS terminal manufacturer).
Pos: 54.11 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0.docx @ 4165 @ @ 1
198