Maintenance
Pos: 64.105 /BA/Wartung/Rundballenpresse/Einstellung der Nockenbremse @ 34\mod_1255606127908_78.docx @ 324956 @ 3 @ 1
13.16.2
Adjusting the cam brake
2
1
Fig. 269
Single axle - compressed air system
At approx. 6 bar of compressed air the brake lever (1) must be located approx. 55 mm from the
plate (2) in brake position.
2
1
Fig. 270
Single axle - hydraulic brake
At approx. 100 bar of oil pressure the brake lever (1) must be located approx. 55 mm from the
plate (2) in brake position.
This setting can be adjusted on the profile of the brake shaft (Fig. RP-00-003):
1. Remove the snap ring (1) and push the brake shaft in as far as possible.
2. Loosen the screw (2).
3. Remove the brake lever (3) and adjust.
4. Tighten the screw (2).
5. Install the snap ring (1).
Pos: 64.106 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0.docx @ 4165 @ @ 1
310
RP-00-001
1
RP-00-002
3
2
RP-00-003