Alarm Messages - Krone Fortima F 1250 Original Operating Instructions

Pos: 52.156 /Überschriften/Überschriften 2/A-E/Alarmmeldungen @ 19\mod_1238572457463_78.docx @ 221082 @ 2 @ 1
8.14

Alarm messages

Pos: 52.157 /BA/Info-Center/CCI-ISOBUS-Terminal/CCI-Rundballenpressen/Hauptmenüs/Alarmmeldungen/Alarmmeldungen allgemein @ 213\mod_1390226364462_78.docx @ 1750401 @ @ 1
F7
F8
F9
F10
F11 F11
F12
Fig. 152
Alarm message
If a fault occurs on the machine, an alarm message appears in the display and an acoustic
signal sounds at the same time (continuous horn). Descriptions of the faults, their possible
causes and how to resolve them are described in the "Alarm messages" chapter.
Note
All functions in the menu that is covered over are still active. The softkeys that are covered by
the alarm message are disabled.
To reset the alarm:
• Briefly press the
If the fault occurs again, the alarm message will appear again.
To delete an alarm:
• Hold down the
immediately and the alarm is deleted.
If the fault occurs again, no alarm message will appear. The alarm message does not appear
when the fault occurs until after the control unit is turned off and back on.
Pos: 52.158 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0.docx @ 4165 @ @ 1
F1
F2
F3
F4
F5
F6
CC000240_1
function button; the alarm is reset and the acoustic signal is stopped.
button for the softkey for 5 seconds; the acoustic signal stops
KRONE ISOBUS Terminal
191