Pos: 60.41.11 /Überschriften/Überschriften 3/K-O/Messer-0-Stellung @ 39\mod_1268811608726_78.docx @ 361945 @ 3 @ 1
11.13.3
Zero position of the cutter
Pos: 60.41.12 /BA/Einstellungen/Schneidwerk/Überschrift Messer mechanisch ausschalten @ 40\mod_1268820694835_78.docx @ 362223 @ @ 1
Switch off cutters mechanically
Pos: 60.41.13 /BA/Einstellungen/Schneidwerk/Messer mechanisch ausschalten @ 39\mod_1268811740054_78.docx @ 361966 @ @ 1
3
Fig. 178
1. Unlock the locking lever (3).
2. Place multipurpose key (1) on blade control shaft (2).
3. Turn blade control shaft (2) with multipurpose key (1) until selector disc (4) is on position
"0". Position „0" is located respectively between two settings of cutters.
Pos: 60.41.14 /BA/Einstellungen/Schneidwerk/Messer mechanisch ausschalten_1 @ 40\mod_1268821737570_78.docx @ 362348 @ @ 1
4. Lock blade control shaft (4) with locking lever (3).
Note
If the round baler is to be operated without cutting system for a long period, it is recommended
to remove the cutters (see Chapter "Change cutters").
Pos: 60.41.15 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0.docx @ 4165 @ @ 1
"0"
2
4
1
VP-1-101
Operation
225