Discharge Chute; Travelling Gear; Central Lubrication System; System Settings - Krone BiG X 600-3 Original Operating Instructions

5.11

Discharge chute

The accelerated crops are conveyed out of the forage harvester via the discharge chute.
The discharge bend can be rotated via a hydraulic motor and the discharge angle can be
adjusted to obtain different discharge widths of the crops.
5.12

Travelling gear

The traction drive is fully hydraulic and is driven by hydraulic motors with wheel motors on the
front wheels (optionally: on all four wheels).
In road mode the traction drive steplessly reaches speed ranges from 0 to 40 km/h, backwards
from 0 to 14 km/h.
In field mode speeds can also be adjusted steplessly forwards from 0 to 25 km/h and
backwards from 0 to 14 km/h.
In field mode a traction control system ("Traction Control") is active.
The traction control system can be adjusted in two stages.
TC II allows increased slip. This setting is usually used in maize mode to ensure sufficient
propulsion even under difficult conditions.
TC I allows only little slip (spinning wheels). This setting is usually used in grass mode to
protect the sward.
The selection of the traction control system stage does not depend on the mode (grass/maize)
set on the terminal.
5.13

Central lubrication system

The central lubrication system supplies selected lubrication points cyclically with an adjustable
amount of lubricant.
5.14

System Settings

The working units, drive and power transmission components are monitored by sensors.
Malfunctions are displayed on the terminal.
The working units, drive and power transmission components can be calibrated from the
terminal.
Machine Description
77