If A Problem Is Found; Figure 6 - Sfp Showing Measured Waveform - Agilent Technologies M9210A Startup Manual

If a Problem is Found

1. Verify that you have set all configuration settings as shown above.
2. Verify that the AWG is ON and producing the desired signals at the end of the BNC cables. This can be
done with an oscilloscope.
3. If the problem occurs during Operational Verification disconnect the input signal and note the status of the
LED on the front panel; it should be GREEN. Reconnect the signal and select the AUTO acquisition mode;
note the behavior for subsequent reference.
4. Verify that the problem is reproducible.
5. Refer to "Return the module for service"
for service.
Agilent M9210A PXI-H 10-bit Digitizing Scope Startup Guide

Figure 6 - SFP showing measured waveform

on page 9, concerning the details on sending the module to Agilent
Conduct M9210A Operational check (optional)
17