Configuration Of Scan To Usb; Configuration Of Scan To Desktop - Fuji Xerox ApeosPort-VII C4421 User Manual

2 Setup
3
Tap [Connectivity & Network Setup] > [Port Settings] > [SMB Client] > [Port Status].
4
Tap [Enabled].
5
Press the Home button.
Note

Rebooting the device is required to enable the settings. Reboot the device following the message on the
screen.
 Enabling the Service and Configuring the Forwarding Method
Configure the My Folder service using CentreWare Internet Services.
1
Start CentreWare Internet Services.
Reference
 For more information, refer to "Starting CentreWare Internet Services" (P.85).
2
Login to the System Administration mode.
3
Click [App] > [Scan] > [Scan to My Folder].
4
Click [Enabled] > [Save].
5
Click [Change My Folder Location].
6
Select either [Disabled] or [Enabled], and then click [Save].
7
Click [My Folder Settings].
8
Set each item and click [Save].
9
Click [My Folder Login Credentials].
10
Select the login credentials to access the destination, and then click [Save].

Configuration of Scan to USB

There are no prerequisites.
You can enable or disable the Scan to USB service using CentreWare Internet Services.
When you disable the service, [Scan to USB] is not displayed on the Home screen, thus you
cannot use the service.

Configuration of Scan to Desktop

Note
 In Windows Server environment, scanning devices are disabled by default. For more information, visit the
official website of Microsoft.
To enable this feature, the following settings are required.
 TCP/IP address
 Enabling port
58