Table of Contents
Advertisement
[Smart Card Reader]
Set whether or not to enable user ID authentication when [Log In to Local Accounts] is
selected and the IC Card Reader (optional) is connected.
Selecting [Smart Card Login] disables the user ID authentication. Selecting [Smart Card /
Control Panel Login] disables both smart card authentication and user ID authentication.
[Account Auto Setup for Card Login]
Set whether or not to register new user information when [Log In to Local Accounts] is
selected and an unregistered user holds a card over the IC Card Reader (optional).
Selecting [Disabled] cancels registering users. Selecting [Enabled] automatically accepts
registering users.
Note
When [Enabled] is selected, [User Name], [Usage Limit], and [Add To Authorization Group] will be displayed.
When [Usage Limit] is selected, [Copy], [Fax], [Scan], and [Print] will be displayed. You can set [Feature Access]
and [Change Account Limit] for each item.
When [Password for Smart Card Login] under [Device] > [Authentication / Accounting] > [Authentication /
Security Settings] > [Authentication] > [Password Policy] is set to [On], you need to enter the password twice
for the auto assign.
[Guest User]
Set whether or not to permit a guest user when [Log In to Remote Accounts] is selected.
[Use of Smart Card]
Set whether or not to use smart card authentication when the IC Card Reader (optional) is
installed on the device.
Selecting [Enabled] allows you to set whether or not to control jobs by smart card per each
feature.
Set to [Enabled (PKI Only)] to restrict only the security feature without using a smart card
for authentication and job restriction.
Note
This item is displayed when the Extensible Customization Function is set to be enabled.
[Smart Card Link Mode]
Set whether or not to require a password for smart card authentication when [Log In to
Remote Accounts] is selected.
[Smart Card Certificate Verification]
Set whether or not to verify the smart card certificate when a user uses the smart card.
When you put a checkmark, the owner of the smart card is verified not only by PIN code
verification but by certification verification of the smart card and private key match. In this
case, the upper level CA certificate of the smart card certification must be registered on the
device.
When you clear the checkmark, the owner of the smart card is verified by PIN code
verification.
[Smart Card Logout Timing]
Select the logout method for smart card authentication when a contactless smart card is
used for authentication.
When [Log Out when Card is Removed] is selected, removing the smart card from the IC
Card Reader (optional) releases the login status. When [Log Out from Control Panel] is
selected, operating the touch screen is required to release the login status.
[Authentication / Accounting]
331
Advertisement
Table of Contents
