Table of Contents
Advertisement
13 Advanced Settings
[Rotate 90 degrees]
Set whether or not to automatically rotate a document if its image must be reduced in size
unless it is rotated.
Note
If an arbitrary magnification is specified in [Reduce / Enlarge], the Rotate 90 Degrees feature does not
function.
[Border Limit]
Set the length to make a page break that will be applied when the length of a received fax
document is longer than the paper length.
This setting can conveniently be used together with the following Auto Reduce on Receipt
feature.
[Auto Reduce On Receipt]
When the length of a received fax document exceeds the paper length but is within the
page break threshold value, select whether or not to automatically reduce the image to fit
the page.
This setting can conveniently be used together with the Border Limit feature. If you clear
the check mark, the part of the image beyond the paper length is ignored.
[2 Pages per Side On Receipt]
Set whether or not to print two pages of a fax document on one side of a sheet. This is
convenient for saving paper.
For example, when two A5 pages are received, they are printed on a single A4 sheet.
However, if paper of the same paper size as the received document is specified in [Receiving
Paper Size], it is printed on the specified size of paper. Depending on the sizes of the
received document, two pages of the document may not be printed on one sheet of paper.
[2 Sided Printing]
Set whether or not to print received Internet fax documents as 2 sided. This is convenient
for saving paper.
Note
Even if a check mark is put, the printing may result in 1 sided due to data.
[Edge Erase - Top & Bottom Edges]
Specify the amount of edges erased from the document in the top and bottom directions.
[Edge Erase - Left & Right Edges]
Specify the amount of edges erased from the document in the left and right directions.
[Reduce 8.5 x 11" Original to A4 ]
When [Reduce / Enlarge] is set to [Auto %], you can set whether or not to reduce 8.5 x 11"
size document to A4, while scanning the document.
[Memory Full Procedure]
If the shortage of storage occurs while scanning an original, a screen appears asking how
you want to handle the partially stored data.
Set the process you want the device to perform for the partially stored data after a certain
time has elapsed in the confirmation screen.
290
Advertisement
Table of Contents
