Table of Contents
Advertisement
Parameter
Item No.
Print control
(Active area
determination
command)
(Paper margin)
(Image
enhancement)
Manual feed tray
check indicator
Emulation target
printer
Pen attributes
800-815 (Pen
width) (No. 0-
No.15)
850-865 (Line
end shape)
(No. 0-No.15)
161
Sets the method to obtain the active coordinate area when auto scaling is
being used.
[0] (Default): Auto
[1]: PS
[2]: IW
[3]: IP
[4]: Adapted
Note
The setting of the active area determination command is valid when [Document
size] is set to [Auto].
162
Sets the paper margin when auto scaling is being used.
[0] - [99] (Default: 0): 0 to 99 mm
Note
The setting of the paper margin is valid when [Document size] is set to [Auto].
163
Sets whether to perform image enhancement, which artificially increases the
resolution of an image and smooth its edges.
[0]: OFF
[1] (Default): ON
165
[0]: None
[1] (Default): Yes
169
Select the device to emulate.
[0] (Default): HP750
[1]: FX4036
Set the width (thickness of the line) of the 16 pens (No. 00 to 15). You can set
the width from 0.0 to 25.5 mm in 0.1 mm increments. No. 00 denotes Item
No. 800.
[0] - [255] (Default: 3): 0 to 25.5 mm
Note
If the image is reduced by concern with the relationship between [Document size]
and [Paper size] settings, the pen width is reduced accordingly to 0.1 mm at the
smallest.
The width of the line gets thick symmetrically with respect to the center of the line.
If the width is set to 0.0 mm, nothing is plotted.
This item does not apply to the character represented by fonts other than the
stroke fonts.
Set the line end shape of the 16 pens (No. 00 to 15). No. 00 denotes Item No.
850.
[0] (Default): Cut
[1]: Round
[2]: Rectangular
[Cut]
: specified coordinate
[Round]
: specified coordinate
[Rectangular]
: specified coordinate
Note
This item does not apply to the character represented by fonts other than the
stroke fonts.
Value
Emulation
503
Advertisement
Table of Contents
