Table of Contents
Advertisement
19 Appendix
Setting Item
Item Number
Reduce/Enlarge
(Reduce/
Enlarge mode)
(Variable %/
magnification
(Variable %/
horizontal
magnification
2 Up mode
Tray 5
confirmation
Grid lines
2 Sided printing
Font
(Alphanumeric
484
54
[0](Default): Preset %
[1]: Variable %
[2]: Fit to Cut Sheet
[Preset %] is a magnification automatically calculated based on [Original
Size] and [Paper Size], and reduces/enlarges the printable area of the
document to fit in the printable area of the output paper. Therefore, when
the size of the document and the output paper are the same, the ratio will be
100%. Also, if [2 Up] is selected, the document will be reduced to the size at
which two pages fit onto one sheet of paper. [Variable %] is a magnification
set in [Variable %] under [Reduce/ Enlarge]. A reference point for scaling
(reducing/enlarging) is the upper left corner of the printable area. This
reference point applies to all text, images, and graphics.
[Fit to Cut Sheet] prints the entire cut sheet area onto the printable area of
the output paper. It is a magnification automatically calculated based on
[Original Size] and [Paper Size], and reduces/enlarges the entire document
(including the area outside of the printable area) to fit onto the printable
area of the output paper.
Note
When a continuous form paper is selected for [Original Size], print result is
identical for [Preset %] and [Fit to Cut Sheet].
17
[45 to 210](Default: 100): 45-210%
vertical
)
18
)
21
[0](Default): Off
[1]: Forward
[2]: Reverse
Important
When [Landscape] is selected for [Original Size], print result is identical for
[Forward] and [Reverse].
67
Prints from Tray 5, after you instruct to print and then operate the device to
start printing.
[0](Default): Off
[1]: On
22
Sets the method for printing double-byte grid lines.
[0](Default): Image
[1]: Font
12
[0](Default): Off
[1]: Head to Head
[2]: Head to Toe
14
Sets the font for single-byte characters.
[0](Default): Roman
fonts)
[1]: Sanserif
Important
Since this feature selects the default value, its setting will not be affected when an
extended command is received.
Value
Advertisement
Table of Contents
