Table of Contents
Advertisement
Setting Item
Number
Paper size
Extended Settings
Setting Item
Item Number
Paper position
Output quantity
Item
2
Sets the size of paper to be printed. This setting can be made only when
[Paper Tray] is set to [Auto] or [Tray 5]. This setting can be configured only for
cut sheets.
[4]: A4
[5]: A5
[15]: B5
[21]: 8.5 x 14
[22]: 8.5 x 13
[23]: 8.5 x 11
[0]: Postcard
Important
When [Tray 1], [Tray 2], [Tray 3], or [Tray 4] is set for [Paper tray], [Paper size]
cannot be set.
Note
When [Preset%] or [Fit to Cut Sheet] is selected for [Reduce/Enlarge], the device
automatically calculates the magnification based on a combination of [Original
Size] and [Paper Size]. If the magnification, however, is outside the range of 45-
210%, the document will not be reduced/enlarged, and will be printed at a scale of
100%. When [2 Up] is selected, the device automatically calculates the
magnification based on a combination of [Original Size] and 1/2 of [Paper Size].
20
[0](Default): Without cut sheet feeder (left)
[1]: With cut sheet feeder (center)
Note
When [Without cut sheet feeder (left)] is specified and FF (line feed command) is
received, the device skips the number of lines specified in VFU. When [With cut
sheet feeder (center)] is specified, the device inserts a page break.
When a continuous form paper is selected for [Original Size], [Paper Position]
cannot be set.
8
[1 to 250] (Default: 1): 1-250 copies
Important
When the output quantity is specified by a client, that number of copies is printed.
After printing, the number set on the control panel is overwritten with the number
newly specified. However, the number of copies specified from the LPD port will
not overwrite the number set on the control panel.
Value
Value
Emulation
483
Advertisement
Table of Contents
