Interface Cables; Using The Ethernet Interface; Using The Usb Interface - Fuji Xerox ApeosPort-VII P5021 User Manual

2 Setup

Interface Cables

Using the Ethernet Interface

Note

The following problems may be resolved by disabling [Energy Efficient Ethernet] under [Device] >
[Connectivity & Network Setup] > [Protocol Settings] > [Ethernet Settings].
 Slow network connection on the device

Unstable network condition of the device which causes frequent timeout errors

The device fails to connect to the network after returning from a long-term Sleep mode
1
Press the Power button and select [Power Off] to switch off the power.
2
Make sure that the touch screen is blank and the Power button is not lit.
3
Connect a network cable to the Ethernet interface connector.
4
Press the Power button to switch on the power.

Using the USB Interface

1
Press the Power button and select [Power Off Device] to switch off the power.
2
Make sure that the touch screen is blank and the Power button is not lit.
3
Connect the USB cable to the interface connector.
4
Connect the other end of the USB cable to the computer.
24