[Wireless Lan Settings]; [Protocol Settings] - Fuji Xerox ApeosPort-VII C4421 User Manual

[Wireless LAN Settings]

You can make the settings for the wireless LAN communication.
Reference

For information on the setting procedures, refer to the manuals accompanying the Wireless Network Kit
(optional).

[Protocol Settings]

Set the parameters required for communications.
[Ethernet Settings]
 [Ethernet 1 - Network Name]
Set the name of Ethernet interface.
Note

This setting is available when the wireless LAN is installed.
 [Ethernet - Rated Speed ] / [ Ethernet 1 - Rated Speed]
Set the communication speed for the Ethernet interface. Select whether to automatically
detect the speed or fix to the desired value according to the network environment to
connect.
 [Energy Efficient Ethernet]
Set whether or not to enable the energy-saving function of the Ethernet interface.
[TCP/IP - Common Settings]
 [Primary Network]
When multiple interfaces are used, the name of interface which works as the primary
network is displayed.
Note

To set the primary network, use CentreWare Internet Service. For details, refer to CentreWare Internet
Services help.
 [IP Mode]
Select the TCP/IP operation mode.
[TCP/IP - Network Settings] / [TCP/IP - Network Settings (Ethernet 1)], [TCP/IP - Network Settings
(Wi-Fi)]
Important

The same IP address as [TCP/IP - Network Settings (Ethernet 1)] and [TCP/IP - Network Settings (Wi-Fi)]
cannot be used. When setting the same IP address to each interface, contact our Customer Support Center.
Note
 The title of this setting item differs depending on the interface configuration: When single interface is used,
[TCP/IP - Network Settings] is displayed. When the Wireless kit is installed, [TCP/IP - Network Settings
(Ethernet 1)] and [TCP/IP - Network Settings (Wi-Fi)] are displayed.

For [TCP/IP - Network Settings (Ethernet 1)] and [TCP/IP - Network Settings (Wi-Fi)], same setting items as
[TCP/IP - Network Settings] are displayed. You can configure individual settings for each interface.
 When any interface names are specified in [Ethernet 1 - Network Name], the specified name is displayed
instead of "Ethernet1".
[Connectivity & Network Setup]
305