Table of Contents
Advertisement
8
Enter the port number where LDAPS runs then tap [OK].
Note
The usual port is 636. Confirm before setting.
9
Press the Home button then tap [Restart Now].
Log in as a LDAP Server User Trusted by Active Directory
The following describes the procedure to log in to the device as a user on the trusted
domain server under the conditions listed below.
The domain name is set to "w2k8adtest.local".
The trusted relationship is established under [Active Directory Domains and Trusts].
1
Tap [Device] on the Home screen.
2
Tap [Connectivity & Network Setup] > [Remote Authentication / Directory Service].
3
Tap [LDAP Server / Directory Service Settings].
4
Set [LDAP Referrals] to [Enabled].
5
As needed, set [LDAP Referral Hop Limit].
Important
The maximum number of servers to connect is the value set for [LDAP Referral Hop Limit]. In the case shown
above, up to five trusted servers are available. You cannot connect to more than five trusted servers.
[Login Credentials to Search Entries] requires the access role to the trusted LDAP servers as well.
For security purpose, the device cannot connect to unencrypted servers when the LDAPS server is configured.
6
Press the Home button then tap [Restart Now].
When the Login Takes Time and the Login Results Vary for the Same User
It is likely to be caused by the high load to the LDAP server or the network. Basically, your
running environment requires to be checked and adjusted.
When the login takes too much time because the search scope of the LDAP server is too
large or the search scope contains too much entries, adjust [Search Directory Root] under
[Connectivity & Network Setup] > [Remote Authentication / Directory Service] > [LDAP
Server / Directory Service Settings].
Setting the waiting time for the connection between the device and the LDAP server long
enough may avoid the login failure. But it is a temporary measure, because the login time is
not shortened.
The procedure to set the waiting time for the connection is as follows.
1
Tap [Device] on the Home screen.
2
Tap [Connectivity & Network Setup] > [Remote Authentication / Directory Service].
3
Tap [Authentication System Setup].
4
Check the following settings and modify if required.
Enabling User Authentication Feature
375
Advertisement
Table of Contents
