Table of Contents
Advertisement
Making the components necessary for the operation exit the Power Saver mode
The device is equipped with the feature to save electricity by supplying only the power to
activate the necessary service when the device exits the Power Saver mode.
Reference
For more information on selecting whether to disable the Power Saver mode fully or partially when exiting
the mode, refer to "[Power Saver Deactivation]" (P.251).
When the Power button is pressed, the touch screen is lit on, but the document feeder and
the output devices do not exit the Power Saver mode. Afterwards, by selecting a service on
the touch screen, the device supplies power only to the components necessary to activate
the service.
Important
The device may not get the correct status of paper or consumables if you load paper or replace consumables
when the device is in the Power Saver mode. Press the Power button and then tap [Device] on the Home
screen > [Paper Tray Settings] or [Supplies] before loading paper or replacing consumables.
Note
When the device receives jobs, the touch screen is not lit on and only the output devices exit the Power Saver
mode and start to print.
When the device receives jobs such as stored print (Secure Print, Delayed Print, Charge Print, and Private
Charge Print), direct fax, and fax using folder receive, and when you access a folder of the device using
CentreWare Internet Services, the touch screen is not lit on and only the storage exits the Power Saver mode.
Power Saver Mode
65
Advertisement
Table of Contents
