Table of Contents
Advertisement
9
Check the printed sample sheet and enter the adjustment value.
10 mm
10 mm
Note
If the printing position of the image is correct, lines are printed 10 mm away from the edges of the sheet. If
you have loaded paper of which size is not suitable for printing sample chart in step 1, the result may not be
reliable.
To show the paper feed direction, squares
the Side 1 and two squares are printed on the Side 2.
Reference
For Lead/Side Registration, refer to "Lead/Side Registration" (P.411).
10
Tap [Adjust].
The adjustment values are set.
11
Tap [Sample Printout] to print another sample sheet and check the adjustment results.
12
Adjust the values again if necessary.
Lead/Side Registration
1
Tap [Lead / Side Registration].
2
Add the adjustment value to the current value and enter it. (1 step = 0.5 mm)
Important
The adjustment values of the lead registration are the same between the tray and the adjustment surface.
You cannot adjust for each.
Note
Adjustment value (mm) = Actual image position distance from paper edge (mm) - 10
Desired image
10 mm
Current image
Paper feed direction
are printed on the tail edge of paper. One square is printed on
10 mm
10 mm
Adjust Paper Registration
10 mm
10 mm
Side registration
misalignment
10 mm
Lead registration
misalignment
411
Advertisement
Table of Contents
