[Remote Authentication / Directory Service] - Fuji Xerox ApeosPort-VII C4421 User Manual

 [Password]
Enter a password for the POP3 server.
 [POP Password Encryption]
Select whether or not to encrypt the password.
[SMTP Server Settings]
You can check the connection between the device and the SMTP server by sending a test
mail to the email address specified in [Connection Test]. Selecting [Connection Test] >
[Print SMTP Comm Report] outputs the report that shows the contents of protocol of the
SMTP communication transmitted and received by the device.
 [SMTP Server Name / IP Address]
Enter a server name or IP address.
 [SMTP Server Port Number]
Enter a port number.
 [Email Send Authentication]
Set the authentication method for SMTP transmission.
Note
 AUTH GSSAPI (only for Kerberos), AUTH NTLMv2, AUTH NTLMv1, AUTH PLAIN, AUTH-LOGIN, or AUTH
CRAM-MD5 can be used as an authentication method.
 [Login Credentials for Email Send]
Set the login user name when sending emails.
When [Remotely Authenticated User] is selected and if the user has logged in to the remote
server before a job startup, the device performs the SMTP server verification with the
remotely authenticated user name and password.
You can also select the post-failure behavior of the device. If you do not set remote
authentication, the device uses the user ID and password of the device for authentication.
 [SMTP AUTH Login Name]
Enter the user name for verification purposes at the SMTP server.
 [SMTP AUTH Password]
Enter the password for verification purposes at the SMTP server.

[Remote Authentication / Directory Service]

[Authentication System Setup]
 [Authentication System]
Allows you to select the authentication system.
Note

When using ApeosWare Management Suite 2 (sold separately) for the remote authentication server, select
[Authentication Agent].
 Azure Active Directory can be set on CentreWare Internet Services. For each setting, refer to CentreWare
Internet Services help.
 Folders and job flow sheets used during the previous authentication system are deleted automatically after:
[Connectivity & Network Setup]
311