[Power Saver Settings] - Fuji Xerox ApeosPort-VII C4421 User Manual

13 Advanced Settings
[Time Zone]
Set the time difference from GMT between -12 and +12 hours.
[Daylight Savings]
Set the daylight saving time. During the period of daylight saving time you set, the device
moves the clock forward by one hour.
[Warmer Mode]
Set whether to switch to the Warmer Mode to prevent or reduce condensation in the device.
 If you select [On] and specify [Start Time] and [Duration], the device enters the Warmer
Mode from [Start Time] to the time period specified on [Duration].
 If you put a check mark for [Auto Start], the Warmer Mode becomes active
automatically based on the prediction of condensation regardless of selecting [On] or
[Off]. The device enters the Warmer Mode at the specified [Start Time].
 If you put a check mark for [Auto Stop], the Warmer Mode becomes deactivated
automatically when no condensation occurs for a certain period.
 If you put a check mark for [Condensation Alert], a message appears when the device
detects the possibility of having condensation.
Note
 The setup by our service representative is necessary depending on the device model. For more information,
contact our Customer Support Center.
 Sleep Mode is not available during the Warmer Mode operation.
[Print-On-Demand Duration]
Specify the duration for the device to receive a print job from web applications. Unless the
device receives full data of the print job within the specified period of time, the device does
not process the print job.
Note

When you send a print job that contains a large amount of data or a print job whose contents take a while to
be processed, transmission may be timed out before the device receives the last page of the print job.

[Power Saver Settings]

[Power Saver Timers]
The Power Saver mode has two modes: the Low Power and Sleep modes. When a specified
period of time has elapsed, the device switches to these modes in the following order to
reduce power consumption.
Last operation on the device  Low Power mode  Sleep mode
Note

You cannot configure the device not to switch to the Low Power mode or the Sleep mode.

The time until entering the Sleep mode should be the same as or longer than the time until entering the Low
Power mode.

If the time until entering the Sleep mode is the same as the time until entering the Low Power mode, the
device skips the Low Power mode to enter the Sleep mode.
[Enter Power Saver]
Sets the transition to the Power Saver mode after the printing received from the computer,
such as printing and fax, are complete.
250