P00--Basic Functions - INVT Goodrive350 Series Operation Manual

Goodrive350 series high-performance multifunction VFD
enter the interface only with the correct user password. For the factory parameters, you need
to enter the correct factory password to enter the interface. (You are not advised to modify the
factory parameters. Incorrect parameter setting may cause operation exceptions or even
damage to the VFD.) If password protection is not in locked state, you can change the
password any time. You can set P07.00 to 0 to cancel the user password. When P07.00 is set
to a non-zero value during power-on, parameters are prevented from being modified by using
the user password function. When you modify function parameters through serial
communication, the user password protection function is also applicable and compliant with the
same rule.
P00––Basic functions
Function
Name
code
Speed control
P00.00
mode
Running
P00.01 command
channel
Communication
running
P00.02
command
channel
Max. output
P00.03
frequency
Upper limit of
P00.04 running
frequency
Description
0:SVC 0
1:SVC 1
2:SVPWM
3:VC
Note: If 0, 1 or 3 is selected, it is required to carry
out motor parameter autotuning first.
0: Keypad
1: Terminal
2: Communication
0: Modbus
1: PROFIBUS/CANopen/DeviceNet
2: Ethernet
3: EtherCAT/PROFINET
4: PLC programmable card
5: Wireless communication card
Note: 1, 2, 3, 4 and 5 are extended functions
which are applicable with corresponding cards.
Used to set the maximum output frequency of the
VFD. It is the basis of frequency setup and the
acceleration/deceleration.
Setting range: Max. (P00.04, 10.00) –630.00Hz
The upper limit of running frequency is upper limit
value of VFD output frequency. This value cannot
be more than the maximum output frequency.
When the set frequency is higher than the upper
limit frequency, the VFD runs at the upper limit
frequency.
Setting range: P00.05–P00.03 (Max. output
-128-
Function parameter list
Default
Modify
value
◎
2
○
0
○
0
◎
50.00Hz
◎
50.00Hz