INVT Goodrive350 Series Operation Manual page 144

Goodrive350 series high-performance multifunction VFD
Function
Name
code
forward/reverse
rotation
Forward/reverse
P01.14 rotation
switch-over mode
P01.15 Stop speed
Stop speed
P01.16
detection mode
Stop speed
P01.17
detection time
Running
protection of
P01.18
power-on
terminal
Action selection
P01.19 when the running
frequency is
Description
the threshold set by P01.14 during setting
forward/reverse rotation of the VFD, as shown
below.
Output frequency f
Forward
Starting
frequency
Setting range: 0.0–3600.0s
0: Switch over after zero frequency
1: Switch over after starting frequency
2: Switch over after passing stop speed and delay
0.00–100.00Hz
0: Set value of speed (the only detection mode
valid in SVPWM mode)
1: Detection value of speed
0.00–100.00s
When the running command channel is controlled
by terminals, the system will detect running
terminal state automatically during power-on.
0: Terminal running command is invalid during
power-on. The VFD will not run during power-on
even if the running command terminal is detected
to be valid, and the system is in running protection
state. The VFD will run only after this terminal is
cancelled and enabled again.
1: Terminal running command is valid during
power-on. The system will start the VFD
automatically after initialization is done if the
running command terminal is detected to be valid
during power-on.
Note: This function must be set with caution,
otherwise, serious consequences may occur.
This function code is used to set the running state
of VFD when the set frequency is below lower limit
frequency.
-135-
Switch over after
starting frequency
Switch over after
zero frequency
Time t
Deadzone
Reverse
time
Function parameter list
Default
Modify
value
◎
1
◎
0.50Hz
◎
0
◎
0.50s
○
0
◎
0