ABB IRB 6660 Product Manual page 87

Illustration, fitting on turning disc
The illustration below shows the mounting holes available for fitting equipment on
the turning disc.
xx0200000197
-
Fastener quality
When fitting tools on the turning disk (see the figures above), only use screws with
quality 12.9.
Standard screws with quality 8.8 may be used when fitting other equipment to the
mounting holes on the upper arm house or frame.
Product manual - IRB 6660
3HAC028197-001 Revision: S
Turning disk (type 2) for all robot versions.
© Copyright 2007-2018 ABB. All rights reserved.
2 Installation and commissioning
2.3.8 Fitting equipment on robot
Continued
87