Cutting Mat - MUTOH Kona 760 Service Manual

Service manual Kona cutting plotter
Part replacement
3.7

Cutting mat

Tools necessary
Isopropanol

Replacement procedure
Please follow the procedure below to replace the cutting mat.
Step 1:
Step 2:
Step 3:
Step 4:
Step 5:
Adjustments necessary
After replacing this part, it is necessary to make the following adjustment.
N°
1
66
Remove the following covers first
Side covers

Y-rail cover

Penhead cover

Refer to Cover removal on page 27
Draw a line in front of the cutting mat and remove the worn cutting mat.
Clean the platen using isopropanol.
Install the new cutting mat in the same position as the previous one.
Reinstall the covers.
Description
YZ calibration
YZ measurement on page 93
Link
AP-74380 - Revision 1.1