Table of Contents
Advertisement
3.1.4
Replacing the cutting mat
To replace the cutting mat, proceed as follows:
Step 1 :
First of all, remove the worn cutting mat (1) by pulling it out, together with the underlying strip of
vinyl (2).
Step 2 :
Depending on the type of grid roll cover, the cutting mat should be installed differently. You can
recognize the type of cover by the amount of holes at the left side (refer to picture below).
Step 3 :
Install the new cutting mat.
a. For TYPE 1
Stick the cutting mat as close as possible to the rear of the machine.
b. For TYPE 2
Stick the vinyl as close as possible to the front of the machine.
Step 4 :
Please contact an Authorized Mutoh technician to perform a Y-Z profile measurement and
sheeting-off knife adjustment.
TYPE 1
REAR
REAR
User's Guide SC-PRO Cutting Plotter
TYPE 2
FRONT
FRONT
24
CHAPTER 3 : BASICS
AP-75280 – Rev. 1.1
Advertisement
Table of Contents
