Problems And Solutions; The Cutting Quality Is Not Good At The Corner Or The End Point; The Media Width Cannot Be Detected Since The Pinch Roller Position Is Not Clear; The Function Of "Set New Origin" Does Not Work - MUTOH ValueCut VC2-1800 Maintenance Manual

Problems and Solutions

This section describes the typical problems you may encounter while operating the cutting plotter and
offers you possible solutions.

The cutting quality is not good at the corner or the end point.

[Check item]

Is the screw on holder loose?

Is the blade worn?

Is AAS offset value adjusted?

Is the media not flat enough?

Is the media wet?

Is the quality of media not good?

Is the drum or pinch roller worn?

The media width cannot be detected since the pinch roller position is not clear.

[Check item]

Is the pinch roller lowered?

Is the width sensor working?

Is the width sensor covered the flag?

Is the flat cable damaged?

Is the width sensor damaged?

Is the carriage board damaged?

The function of "Set New Origin" does not work.

[Action]
Set a media on the ValueCut, and Press ENTER key when LCD displays the X/Y distance from the old
origin.
VC2E-MM-00
[Action]
Tighten the screw firmly.
Replace the blade.
Adjust the offset value.
Reload the media.
Replace the media.
Change the media.
Replace the drum set or pinch roller.
[Action]
Lower the lever and release the lock.
Adjust the board mounting position.
Check the board mounting position.
Replace the cable.
Replace the carriage board.
Replace the carriage board.
55
MAINTENANCE MANUAL