Table of Contents
Advertisement
Then turn the roll downward to make an equal tension across the media
(See Figure 4-16)
Make sure that the media
tension is equally distributed
from left to right. If the media
is not tight enough against the
platen, it will cause tracking
problems.
4.
Engage pinch rollers.
5. Fixes roll media guide bushes on the roll holder to secure the roll media.
6. The protrusion length of the blade should be longer than the thickness of the vinyl.
(Please check the "Blade Specification: About the Tool" in Appendix.) After you
notice all the above, you'll enjoy your gigantic signs production!
4.6
When Completing the Cutting Job
After completing the cutting job, raise the sheet-loading lever, and then remove the material.
You can also cut off the finished job by the Safe Blade (a standard accessory) along the knife
guide. (Figure 4-17)
Operation
Figure 4-16
Figure 4-17
4-9
ValueCut User Manual
Hide quick links:
Advertisement
Table of Contents
