When Completing The Cutting Job - MUTOH VC-600 User Manual

Sign cutting plotter

Hide thumbs Also See for VC-600:

Table of Contents

ValueCut USER MANUAL

Then turn the roll downward to make an equal tension across the media (See Figure 4-16)

Make sure that the media tension is

equally distributed from left to right. If the

media is not tight enough against the

platen, it will cause tracking problems.

Engage pinch rollers.

Fixes roll media guide bushes on the roll holder to secure the roll media.

The protrusion length of the blade should be longer than the thickness of the vinyl.

(Please check the "Blade Specification: About the Tool" in Appendix.) After you notice all

the above, you'll enjoy your gigantic signs production!

4.6 When Completing the Cutting Job

After completing the cutting job, raise the sheet-loading lever, and then remove the material. You can

also cut off the finished job by the Safe Blade (a standard accessory) along the knife guide. (Figure 4-17)

V5a 2015 Jan

Figure 4-16

Figure 4-17

Operation

Table of Contents

Vc-1300 Vc-1800