When Completing The Cutting Job - MUTOH ValueCut II VC2-600 User Manual

Operation
4. Then turn the roll downward to make an equal tension across the media.
(See Figure 4-16)
Make sure that the media tension is
equally distributed from left to right. If the
media is not tight enough against the
platen, it will cause tracking problems.
5. Engage pinch rollers.
6. Fixes roll media guide bushes on the roll holder to secure the roll media.
7. The protrusion length of the blade should be longer than the thickness of the vinyl.
(Please check the "Blade Specification: About the Tool" in Appendix.) After you notice
all the above, you'll enjoy your gigantic signs production!

4.6 When Completing the Cutting Job

After completing the cutting job, raise the sheet-loading lever, and then remove the material. You can
also cut off the finished job by the Safe Blade (a standard accessory) along the knife guide. (Figure 4-17)
Figure 4-16
Figure 4-17
54
ValueCut USER MANUAL
VC2E-A-00