Exit Conveyor - Challenge CMT-130TC Service Manual

Outfeed Option 2:

Exit Conveyor

Figure 8-35. Exit Conveyor
Setup Procedure
1. Remove (4) sets of screws and washers
from the right side of the trimmer, near and
on the power panel cover. Save them for
later use.
2. Adjust the leveling feet of the Exit Conveyor
such that the conveyor surface is approxi-
mately 33-7/8" (86.0 cm) from the floor and
level, as shown in Figure 8-36.
CMT-130TC Book Trimmer
Figure 8-36. Exit Conveyor Height
3. Move the Exit Conveyor to the right-hand
side of the trimmer such that the slots in the
conveyor mounting brackets line up with the
holes in the side of the trimmer.
4. Fasten the conveyor to the trimmer using
the hardware from step 1.
Cable and Air Tubing Connections
1. Remove the lower front panel of the trimmer
and locate the yellow power cable coiled up
inside the trimmer that is labelled with the
number that corresponds to the label on the
exit conveyor near the input connectors.
The power cables are the larger diameter
cables with 7-pin connectors on the end.
2. Route the power cable under the electrical
enclosure and out of the right side of the
trimmer.
3. Connect the power cable as shown in Figure
8-37.
MAY 2019
8-15
Figure 8-37. Power Cable Connection
4. Now locate the yellow communication cable
that is labelled with the number that corre-
sponds to the label on the exit conveyor
near the input connectors. It is a small di-
ameter cable with a 3-pin connector on the
end. The cable will come from either the ele-
vator or pile feeder (if equipped), otherwise
from inside the trimmer.
5. Connect the communication cable as shown
in Figure 8-38.
Figure 8-38. Comm. Cable Connections
Now go to Section 8.7 Main Power Hookup to
continue the setup process.
8. Installation