Long Hand-Feed Conveyor - Challenge CMT-130TC Service Manual

Infeed Option 5:

Long Hand-Feed Conveyor

Figure 8-26. Long Hand-Feed Conveyor
Setup Procedure
1. Move the trimmer to the appropriate loca-
tion.
2. Remove (4) sets of screws and washers fas-
tened to the side of the trimmer just above
the left-hand side door as shown in Figure
8-27. Save them for later use.
3. Make sure the reflector bracket is in place
as shown in Figure 8-27.
CMT-130TC Book Trimmer
Figure 8-27. Hand Feed Mounting Hardware
4. Initially set the Hand-Feed Conveyor's level-
ing pads at approximately 2-1/4" (5.7 cm) as
shown in Figure 8-28
Figure 8-28. Hand-feed Leveling Pads
5. Move the Hand-Feed Conveyor to the left-
hand side of the trimmer such that the slots
in the conveyor mounting brackets line up
with the holes in the trimmer's left-hand side.
It may be necessary to adjust the Hand-
Feed Conveyor's leveling pads in order for
the mounting brackets to line up properly.
6. Fasten the conveyor to the trimmer using
the hardware from step 2.
MAY 2019
8-11
Cable Connections
1. Remove the lower front panel of the trimmer
and locate the yellow power cable coiled up
inside the trimmer that is labelled with the
number that corresponds to the label on the
hand-feed conveyor near the input connect-
ors. The power cable has a 5-pin connect-
ors on the end.
2. Route the power cable under the hydraulic
unit and out of the left side of the trimmer.
3. Connect the power cable as shown in Figure
8-29.
Figure 8-29. Power Cable Connection
Now go to Section 8.5 Trimmer Height Setup to
continue the setup process.
8. Installation