Gp 6.9 Barcode Scanner - Challenge CMT-130TC Service Manual

GP 6.9 Barcode Scanner

The CMT-130TC uses a barcode scanner to
scan barcodes printed on the covers of books as
they enter the trimmer. The trimmer uses the in-
formation in the barcode to set trim sizes for
each book.
For more information about the barcode capabil-
ities and settings, see the CMT-130TC's Installa-
tion and Operator's Manual.
The barcode scanner can be reset if necessary
using the following procedure.
Procedure
1. Switch the main power ON and press the
green start button to initialize the trimmer.
2. Press the "Job" button, then press the "Bar
Code" button to open the barcode job
screen.
3. Near the lower right of the screen (Figure
6-12), select the desired barcode format
(Code 128, Data Matrix, etc.).
4. Now press the "Program BarC Reader" but-
ton at the lower right corner of the screen.
5. The barcode scanner should emit a brief se-
quence of beeps indicating that the pro-
gramming was successful for the selected
barcode format.
6. General Procedures/Information
Figure 6-11. Barcode Scanner
Figure 6-12. Barcode Job Screen
MAY 2019
6-10 CMT-130TC Book Trimmer