Table of Contents
Advertisement
8.1 Shipping Claims
The CMT-130TC has been packed to prevent
damage during shipment. Claims for damage or
loss are the responsibility of the recipient. In-
spect all shipments as soon as they are re-
ceived. If there is any noticeable damage, note
it on the freight bill. Visual and/or hidden dam-
age must be reported to the claims department
of the carrier within 15 days. Contact your
dealer if you need any assistance. Check the
contents of the crate against both the packing
list in the Installation and Operator's Manual and
the freight bill. Make sure there are no missing
items.
8.2 Unpacking
Remove the packing materials and the two lag
screws. One lag screw is located at each end of
the machine, behind the front cover and rear
door as shown in Figure 8-1.
Figure 8-1. Lag Screw Locations
8. Installation
Remove Lag Screws
1. Remove 4 screws from the front cover using
a 1/8" hex wrench.
2. Using a 9/16" wrench, remove the lag screw
from the front location shown in Figure 8-1.
3. Open the rear door.
4. Remove the belt guard near the bottom of
the machine to reveal the rear lag screw.
5. Remove the rear lag screw.
6. Close the rear door.
Use a forklift to remove the machine from the
skid and place it as close as possible to its in-
stallation location. The machine has accessory
power cables and air hoses wrapped-up and
placed inside the machine. Be careful not to
pinch or entangle these in the forks.
Figure 8-2. Fork Locations for Lifting
MAY 2019
8-2
8.3 Moving
Once the machine is near its final location, it can
be rolled into place.
WARNING
Do not roll on a graded surface. Roll only on
a flat surface. Personal injury could result.
It may be necessary to raise the four leveling
pads in order to roll the machine. A pad is lo-
cated under each corner of the machine. Using
either a 3/4" open-ended wrench or an adjusta-
ble wrench, turn the leveling pad counterclock-
wise to raise it.
Figure 8-3. Leveling Pads
Push the CMT-130TC into position. Do not
lower the leveling pads at this time. Its final po-
sition may require slight adjustment depending
upon the setup.
CMT-130TC Book Trimmer
Advertisement
Table of Contents
