8.6 Outfeed Setup; Vertical Outfeed Stacker - Challenge CMT-130TC Service Manual

8.6 Outfeed Setup

There are (3) available CMT-130TC outfeed op-
tions:
Option 1:
Vertical Outfeed Stacker (58000TCA)
Option 2:
Exit Conveyor (56420TCA)
Option 3:
Exit Ramp (59093)
Any of these options can be used regardless of
the trimmer configuration (in-line or stand-
alone).
The following procedures show how to setup
each of the 3 outfeed options.
CMT-130TC Book Trimmer
Outfeed Option 1:

Vertical Outfeed Stacker

Figure 8-31. Vertical Outfeed Stacker
Setup Procedure
1. Setup the outfeed stacker according to the
instruction and parts manual supplied with
the outfeed stacker.
2. Move the outfeed stacker into position
against the trimmer, aligning the 2 pins on
the side of the trimmer with the correspond-
ing holes in the outfeed stacker.
Cable and Air Tubing Connections
1. Remove the lower front panel of the trimmer
and locate the yellow power cable coiled up
inside the trimmer that is labelled with the
number that corresponds to the label on the
outfeed stacker near the input connectors.
The power cables are the larger diameter
cables with 7-pin connectors on the end.
MAY 2019
8-13
2. Route the power cable under the electrical
enclosure and out of the right side of the
trimmer.
3. Connect the power cable as shown in Figure
8-32.
Figure 8-32. Power Cable Connection
4. Now locate the yellow communication cable
that is labelled with the number that corre-
sponds to the label on the outfeed stacker
near the input connectors. It is a small di-
ameter cable with a 3-pin connector on the
end. The cable will come from either the ele-
vator or pile feeder (if equipped), otherwise
from inside the trimmer.
5. Connect the communication cable as shown
in Figure 8-33.
8. Installation