Standard Hand-Feed Conveyor - Challenge CMT-130TC Service Manual

Infeed Option 4:

Standard Hand-Feed Conveyor

Figure 8-23. Standard Hand-Feed Conveyor
Setup Procedure
1. Move the trimmer to the desired location.
2. Remove (5) sets of screws and washers fas-
tened to the side of the trimmer just above
the left-hand side door as shown in Figure
8-24. Save them for later use.
3. Make sure the reflector bracket is in place
as shown in Figure 8-24.
8. Installation
Figure 8-24. Hand Feed Mounting Hardware
4. Fasten the conveyor to the trimmer using
the hardware from step 2.
Cable Connections
1. Remove the lower front panel of the trimmer
and locate the yellow power cable coiled up
inside the trimmer that is labelled with the
number that corresponds to the label on the
hand-feed conveyor near the input connect-
ors. The power cable has a 5-pin connect-
ors on the end.
2. Route the power cable under the hydraulic
unit and out of the left side of the trimmer.
3. Connect the power cable as shown in Figure
8-25.
MAY 2019
8-10
Figure 8-25. Power Cable Connection
Now go to Section 8.5 Trimmer Height Setup to
continue the setup process.
CMT-130TC Book Trimmer