Viewing Ilmi Statistics - Lucent Technologies PacketStar PSAX User Manual

Chapter 6 Configuring the Interfaces Using the AQueView
Configuring the ATM PNNI Interface
Viewing ILMI
Statistics
Table 6-7. Field Descriptions for the ILMI Statistics Page
Field Name
Link Resets
(display only)
Attachment Point
Changed
(display only)
Attachment Point
Verified
(display only)
Secure Link Proc
Initiated
(display only)
ILMI Timeouts
(display only)
Packet Discarded
(display only)
Cold Starts Trans-
mitted
(display only)
Cold Starts
Received
(display only)
®
PSAX 6-Port DS1 IMA Module User Guide, Issue 1
PacketStar
6-34
addresses. If the scope is not set by the user, it will default to global (a
value of 15).
2 To go back to the ATM UNI Interface Configuration window, click Close.
End
You can view ILMI statistics on the ILMI Statistics panel of the ILMI Configu-
ration page (see Figure 6-7).
Descriptions of the ILMI statistics data fields are given in the following table.
Field Values
Default: 0
Range: N/A
Format: Numeric
Default: 0
Range: N/A
Format: Numeric
Default: 0
Range: N/A
Format: Numeric
Default: 0
Range: N/A
Format: Numeric
Default: 0
Range: N/A
Format: Numeric
Default: 0
Range: N/A
Format: Numeric
Default: 0
Range: N/A
Format: Numeric
Default: 0
Range: N/A
Format: Numeric
®
EMS
Description
Number of times connectivity went down and
then up again.
Number of times attachment point change was
detected.
Number of times attachment point was verified
successfully.
Number of times the secure link procedure was
initiated.
Number of times the Get Request of any type was
timed out.
Number of times a packet (pdu) was discarded
due to format error.
Number of times a Cold Start trap message was
transmitted.
Number of times a Cold Start trap message was
received.
Release 8.0
255-700-268