Parameters - Siemens SINAMICS G130 Operating Instructions Manual
Converter built-in units 75 kw-800 kw
Hide thumbs
Also See for SINAMICS G130:
- List manual (1976 pages) ,
- Engineering manual (530 pages) ,
- Manual (312 pages)
Table of Contents
Advertisement
9.2.7.4
Parameters
• r0051
• p0130
• p0180
• p0186
• p0819[0...2]
• p0820
• p0821
• p0822
• p0823
• p0824
• p0826
• p0827
• p0828
• r0830
• p0831
• p0833
9.2.8
Friction characteristic curve
Description
The friction characteristic is used to compensate for the frictional torque of the motor and
driven load. A friction characteristic allows the speed controller to be pre-controlled and
improves the control response..
10 points along the characteristic are used for the friction characteristic. The coordinates of
every interpolation point are defined by a speed parameter (p382x) and a torque parameter
(p383x) (point 1 = p3820 and p3830, point 10 = p3829 and p3839).
Features
● There are 10 points along the characteristic to represent the friction characteristic.
● An automatic function supports the friction characteristic plot.
● A connector output (r3841) can be interconnected as friction torque (p1569).
● The friction characteristic can be activated and deactivated (p3842).
Inverter chassis units
Operating Instructions, 07/2016, A5E00331449A
Drive data set DDS effective
Motor data sets (MDS) number
Drive data set (DDS) number
Motor data sets (MDS) number
Copy drive data set DDS
BI: Drive data set selection DDS, bit 0
BI: Drive data set selection DDS, bit 1
BI: Drive data set selection DDS, bit 2
BI: Drive data set selection DDS, bit 3
BI: Drive data set selection DDS, bit 4
Motor changeover, motor number
Motor changeover status word bit number
Motor changeover, feedback signal
Motor changeover, status
Motor changeover, contactor feedback signal
Data set changeover configuration
Functions, monitoring, and protective functions
9.2 Drive functions
403
Advertisement
Table of Contents
